The price of the jet mill can crush the raw materials into ultra-fine powder, and then continue to sieve the fine powder into coarse powder, fine powder and ultra-fine powder of different particle size levels. The surface area of ​​the raw material processed by the jet mill will increase, further improving the physical effect or chemical reaction speed of the raw material, thereby increasing its application value. It is widely used in the chemical industry, minerals, metallurgy, abrasives, ceramics, refractory materials and new materials industries. Therefore, there are many people who use it, and the advantages it brings to people are also very big. After learning its maintenance method and also learning its maintenance method, do you know what to do when the price of the jet mill is started? ? Let's take a look with the editor below.

Before starting the price of the jet mill, please manually roll the rotor to check whether the jaws, hammer and rotor work flexibly and reliably, whether the shell collides, and whether the rotation direction of the rotor is consistent with the rotor. The direction pointed by the machine arrow. The smoothness of the grinder is not very good either. In case the speed is too high and explosive crushing occurs in the crushing cavity, or the speed is too low and affects the operating efficiency of the crusher, do not change the pulley at will. After starting, the jet mill should be idling for 2-3 minutes, and then feed operation after there is no abnormal appearance. In the process of operation, always pay attention to the working state of the crusher, and the feed rate must be uniform to prevent jamming of the car and not overload the work for a long time. If there are signs of vibration, noise, high temperature of the bearing and body, or signs of sprayed materials, the machine should be shut down immediately for inspection, and the operation can be continued after troubleshooting.

The above is the introduction of this editor about its related knowledge, I hope you can learn more about it through the introduction of the above editor.