Do you know why there is a speed difference inside the jet mill? Mainly because there is a difference between the hammering speed in the machine and the material in the machine, so there will be a speed difference. If this speed difference is not resolved, the efficiency of the shredder will be affected. Therefore, how to reduce the internal speed difference of the machine is very important. Let's follow the price editor of the jet mill to understand it!

1. Properly adjust the gap between the hammer and the sieve: using the friction characteristics of the sieve surface to change with the distance between the material and the sieve surface, by adjusting the gap between the hammer and the sieve, the difference in the hammering speed between the hammers and the increase of the material, thus Increase the ratio. However, in the feed production process, the sieve hole is different, the raw material is different, and the hammer-screen gap needs to be adjusted frequently; in the air jet mill, the particle composition of the inner cavity will also change after starting work and working for a period of time. Among the components of the jet mill, the hammer is easy to wear. After the front end of the hammer blade is worn, the change of the hammer screen gap increases, and the output decreases, which is difficult to sustain. Of course, in order to test the output of a certain type of jet mill, for certain raw materials and certain sieve holes, please determine the appropriate hammer sieve clearance and suction. Regardless of the service life of the sieve and hammer, its service life can be shortened. Obtained very high crushing efficiency data within a period of time. However, in the production of feed crushing, the various specific measurement data that appear on the condition of the operator’s work experience and the technical content of the jet mill itself are two different things. The personnel with rich operating experience and their labor are also different. Requires high usage cost. After the hammer is worn, the clearance between the hammer and the screen increases, the friction is reduced, and the crushing efficiency decreases.

2. Reasonable use of burrs on the reverse side of the sieve: Put the punched and hairy side of the sieve inside to increase friction, but it will not take long. After the burrs on the sieve are polished, the efficiency is gone. The lasting time is about 30 minutes to 1 hour. .

The above is the relevant knowledge of the airflow mill price editor about its internal speed difference, you can learn more.